PHI end-finishing machines are the end result of more than forty years experience in producing tube-processing equipment (as Leonard Precision until 1969 and as Conrac's Machine Tool Division until 1985).

There is a standard machine in the PHI line for almost any tube or pipe end-finishing requirement - flaring, double flaring, beading, squaring, deburring or flanging - for application ranging from 1/8 inch light-wall tubing to 8-inch pipe.

As labor saving devices, the PHI end-finishing machines can directly replace manual tools, which are appropriate only when extremely low output is required. Manual devices may, moreover, fail to form the material to specifications, or may be ineffective for tube or pipe sizes of 1 inch OD or up. This may require in turn mechanical fittings which are extremely expensive and do not form a sufficient joint to meet many military or federal specifications.

To increase efficiency, every PHI machine features simplified set-up procedures with minimum time loss in small-lot production changeover. The PHI designs also permit new operators to run the machines at near top efficiency after a very short training period.

All of PHI's production machinery and tooling are manufactured on our own premises, assuring you that our rigid quality specifications are met on every item we ship.

The Capacity Chart briefly lists the PHI machines and their areas of application.

We maintain a constant inventory of all popular sizes of tooling for end-finishing tubes and pipes to military and industrial standards. We also prepared to design and manufacture special tooling to the user's specifications. Consult the factory for cost and delivery schedules.